Home»Grades > Special Alloy > X1NiCrMoCu25-20-5

UNE X1NiCrMoCu25-20-5Enquiry|Print this page

X1NiCrMoCu25-20-5Application:Spain structural alloy steel
CategoryTypeSteel gradeStandardCountry
Grades Special Alloy X1NiCrMoCu25-20-5UNESpain

Chemical composition%of the ladle analysis of gradeX1NiCrMoCu25-20-5

C(％)Si(％)Mn(％)P(％)S(％)Cr(％)Ni(％)Mo(％)N(%)Cu(%)
0.0200.702.000.0300.01019.0-21.024.0-26.04.00-5.00Max 0.151.20-2.00
X1NiCrMoCu25-20-5
Mechanical properties of gradeX1NiCrMoCu25-20-5
Proof strength
Rp0.2(MPa)		Tensile strength
Rm(MPa)		Impact energy
KV(J)		Elongation at fracture
A(%)		Reduction in cross section on fracture
Z(%)		As-Heat-Treated ConditionBrinell hardness(HBW)
953(≥)982(≥)442321Solution and Aging,Annealing,Ausaging,Q+T,etc441
Physical properties of gradeX1NiCrMoCu25-20-5
PropertyDensity
kg/dm3		Temperature T
°C/F		Specific heat
J/kgK		Thermal conductivity
W/mK		Electric resistance
µΩ·cm		Modulus of elasticity
kN/mm2		Expansion rate
627(≥)555(≥)232213Solution and Aging,Annealing,Ausaging,Q+T,etc444
Temp.
°C/°F		Creep strain limit
(10000h)
(Rp1,0)N/mm2		Creep rupture strength
(10000h)
(Rp1,0)N/mm2
365544322
X1NiCrMoCu25-20-5Range of products
Product typeProductsDimensionProcessesDeliver Status
Plates/SheetsPlates/Sheets0.08-200mm(T)*W*LForging,hot rolling and cold rollingAnnealed,Solution and Aging,Q+T,ACID-WASHED,Shot Blasting
Steel BarRound Bar,Flat Bar,Square BarΦ8-1200mm*LForging,hot rolling and cold rolling,CastBlack,Rough Turning,Shot Blasting,
Coil/StripSteel Coil/Steel Strip0.03-16.0x1200mmCold-Rolled&Hot-RolledAnnealed,Solution and Aging,Q+T,ACID-WASHED,Shot Blasting
Pipes/TubesSeamless Pipes/Tubes,Welded Pipes/TubesOD:6-219mm x WT:0.5-20.0mmHot extrusion,Cold Drawn,WeldedAnnealed,Solution and Aging,Q+T,ACID-WASHED
Cross Reference Table(Equivalent Grade)
GradeStandardCountryApplication
Y1Cr18Ni9UNESpain
Improve the machinability, ablation resistance. Suitable for automatic lathe production of bolt and nut
1Cr18Ni9UNESpain
High strength after cold forming, but elongation than 1 cr17ni7 slightly worse. Used in architectural decoration parts
1Cr18Mn10Ni5Mo3NUNESpain
Of urea with good corrosion resistance, can produce urea corrosion of the equipment.
1Cr17Ni7UNESpain
High strength after cold forming. Used in railway vehicle, conveyor belt, bolt and nut, etc
Y1Cr18Ni9SeUNESpain
Improve the machinability, ablation resistance. Suitable for automatic lathe production of rivets, screws
0Cr18Ni9UNESpain
Seamless stainless steel tubes for boiler and heat exchanger
00Cr19Ni10UNESpain
Carbon content lower than 0Cr19ni9 steel, excellent intergranular corrosion resistance, is used for welding after the class is not processed parts
1Cr17Mn6Ni5NUNESpain
Nickel steel grade, instead of number 1 cr17ni7 and magnetism after cold working, used in railway vehicle, etc
1Cr18Mn8Ni5NUNESpain
Nickel steel, instead of 1cr18ni9
0Cr19Ni9NUNESpain
Based on 0cr19ni9 plus N, strength increase and the plastic is not down. Reduce the thickness of the material. As a structure with strength components
0Cr19Ni10NbNUNESpain
Based on zero cr19ni9 plus N and Nb, with better than 0 cr19ni9 properties and USES
00Cr18Ni10NUNESpain
In 00cr19ni10 adding N, on the basis of the above grades also features, use the same as the 0 cr19ni9n, but better intergranular corrosion resistance
1Cr18Ni12UNESpain
Compared with 0 cr19ni9, processing low hardenability. Used for spinning processing, special drawing, cold heading
0Cr23Ni13UNESpain
Corrosion resistance and heat resistance are better than 0cr19ni9
0Cr25Ni20UNESpain
Oxidation resistance is better than 0cr23ni13. Mostly used as heat resistant steel
0Cr17Ni12Mo2UNESpain
Seamless stainless steel tubes for boiler and heat exchanger
1Cr18Ni12Mo2TiUNESpain
Seamless stainless steel tubes for boiler and heat exchanger
0Cr18Ni12Mo2TiUNESpain
Seamless stainless steel tubes for boiler and heat exchanger
A-29 1025UNESpain
General use carbon steel rod
1025UNESpain
These products have been used typically for use in fabrication of fittings, but usage is not limited to such applications. These products are not typically used for deep forming or cupping operations.

Relevant products

X1NiCrMoCu25-20-5 Steel Stock

Steel gradeDimensionShapeUnitQuantityDelivery stateQuery
SkD-11 Round Bar StockΦ30-Φ350Round BarKgs3102Hot-Rolled+Annealed+blackEnquiry
17-4PH Coil Stock0.08*200mmCoil or StripKgs1623Cold-Rolled+AnnealedEnquiry
D2 Round barΦ25-Φ380mmRound BarKgs45325Hot-Rolled+Annealed+blackEnquiry
Cr8 flat bar12*355*LFlat or Square barKgs3965Forged+Annealed+blackEnquiry
17-4PH Round BarΦ5-300mm*LRound BarKgs46958Hot-Rolled+Annealed+blackEnquiry
17-4PH plate8-45*1200*3000mmPlate or SheetTons4.9Hot-Rolled+Annealed+blackEnquiry
Cr12MoV12-160(T)*310-610(W)*LPlate or SheetTons12.38Hot-Rolled+Annealed+blackEnquiry
1.260112-160(T)*310-610(W)*LPlate or SheetTons11.22Hot-Rolled+Annealed+blackEnquiry
IncoloyA-286 / GH 2132 StockΦ8-65mm*LRound BarKgs489Hot-Rolled+Annealed+blackEnquiry
Incoloy800 round barΦ115*1400Round BarKgs169Hot-Rolled+Annealed+blackEnquiry
17-7PH / 631 Coil & Strip, Sheet Stock0.3-3.0*10-180mmCoil or StripKgs1236.22Cold-Rolled+AnnealedEnquiry
X22CrMoV12-1 / 1.4923Φ17mmRound BarKgs300Hot-Rolled+Annealed+blackEnquiry
1.2083 Forged PlateT:105-185mm*W:510*LPlate or SheetTons26Forged+QTEnquiry
X22CrMoV12-1 / 1.4923Φ30mmRound BarKgs300Hot-Rolled+Annealed+blackEnquiry
1.4882 strip/sheet/plate stock3.5x200x1000-2000mmCoil or StripKgs200Cold-Rolled+AnnealedEnquiry
A387 F5 & Grade 5 sheet Coil strip0.5mmx200mmxCCoil or StripTons3Cold-Rolled+AnnealedEnquiry
A387 F5 & Grade 5 Hot Coil stockSelectTons3Hot-Rolled+Annealed+blackEnquiry
T45Cr5Si3 Round BarDia.40mmRound BarKgs500Hot-Rolled+Annealed+blackEnquiry
UNS K30960(VIM+ESR) Bright Round BarDia.22mmRound BarKgs50Hot-Rolled+Annealed+blackEnquiry
SA-437 Grade B4B/SUS 616 /422 Forged BarDia.160xLRound BarKgs2120Forged+QTEnquiry

Enquiry